Welcome to part two of my binding tutorial!
We are starting with the trimmed quilt and binding strip that we prepared in part one.
Now we are going to attach the binding to the front of the quilt by machine.
First you need to set up your needle position. I like to sew my binding on with just over 1/4" (about 5/16") allowance.
Use your ruler to work out where your needle needs to be. If you have a machine where you can adjust the needle position, this is easy.
If you can't adjust your needle, work out where you need the edge of the quilt to be as you are sewing. You can mark this with a bit of masking tape.
I use my walking foot when attaching the binding.
Now lay the binding on top of the quilt with the raw edges together.
Make sure you leave a really generous allowance of binding free - at least 10" for joining at the end.
Start sewing your binding about halfway down one side of the quilt. Stitch length about 2-2.5mm.
As you approach the corner, stop and make a mark 5/16" from the end:
When you reach this mark, stop sewing and cut the thread. Take the quilt out from the machine.
Now go on to part three - corners.